• 首页
  • 期刊简介
  • 编委会
  • 投稿须知
  • 审稿指南

    • 谢思瑜，李铁，黄帅，马鹏飞，依平.不同参数对激光诱导磷光测温技术的影响[J].内燃机工程,2021,42(1):102-108.
    Influence of Laser Energy and Phosphorescent Coating Parameters on Laser-Induced Phosphorescence Temperature Measurement Technology
    DOI：10.13949/j.cnki.nrjgc.2021.01.015
    Key Words:phosphor thermometry  CMOS high-speed photography  laser energy  coating thickness  mixing ratio
    Author NameAffiliation
    XIE Siyu,LI Tie,HUANG Shuai,MA Pengfei,YI Ping 1.State Key Laboratory of Ocean Engineering, Shanghai Jiao Tong University, Shanghai 201100, China
     2.Collaborative Innovation Center for Advanced Ship and Deep Sea Exploration, Shanghai 201100, China 
    摘要点击次数: 4019
    全文下载次数: 1516
    Abstract:The CMOS high-speed photography was used to build a two-dimensional laser-induced phosphorescence temperature measurement system, and a calibration experiment was conducted. The effects of laser energy, mixing ratio between MFG and binder and coating thickness on the decay time of Mg3F2GeO4:Mn (MFG) were studied. The results show that when the temperature of coating exceeds the quenching point, the MFG decay period extends with the coating thickness, and the difference of the MFG decay extension of different coating thicknesses enlarges with the temperature. The excitation energy in the range of 0.3～11.0mJ can excite the MFG phosphorescence. And the level of the excitation energy has a little influence on the MFG decay time, so dose the MFG mixing ratio. However, a properly diluted MFG responds quickly at low temperatures and exists longer at high temperatures. This is a preferred feature for the temperature measurement in complex environments like combustion chamber.
    查看全文  查看/发表评论  下载PDF阅读器